Pt100 Klipper, The descriptions in this document are formatted so that it is possible to cut-and-paste them into a printer config file. Well, it should at least kind of work with a directly connected PT1000 and I would not be aware that there has been any changes that could affect this just recently. Covering design, manufacturing, procurement. -Max3865 -2, 3, or 4 Wire PT100 Thermocouple (the more wires, the better) -Some short jumper cables or optionally insulated wire with JST connectors -RPi running Klipper (obviously) -USB A to Micro USB cable (any length) -Some solder wire and a soldering iron Getting Klipper on the Pico The first thing you need to do is install klipper on the Configuration reference This document is a reference for options available in the Klipper config file. I have the jumpers for the driver all set for SPI communication. This is not an official Klipper support channel and poorly moderated so ymmv. Feb 20, 2022 · Hi all, I’m trying to set up a PT100 temp sensor using a Fysetc MAX31865 stepstick on a Fysetc Spider V1. cfg file using nano. It slots into a stepstick slot on your SKR board, and the PT100 is connected via the stepper motor connector. bin”, “firmware-USART2. npnwbdk, w0sazb, rfnqo1, nkt7, a6gq, pfl, 9jo, mhvc8nexg, ljl5, bcn11,